Common fault solutions for zippers

1. When the opening and closing are not smooth, if the chain head is pulled hard, the tooth element oclocking fault will occur.At this time with paraffin or lubrication spray [zipper with (FASTENERMATE)] coated on the surface and inside of the teeth, and then move the pull head several times after sliding loose.

2. If the zipper on the bag is loaded too much, if the zipper is closed and closed, the force on the zipper is too large, it will make the teeth get out of the belt.This is serious when it comes to the failure of the zipper.Pull the left and right teeth closer so that the chain head can pass easily before closing the zipper.

3. When opening and closing the zipper, sometimes the chain head bites the line segment or the cloth so that the pull head does not move. In this case, if you want to pull the head strongly, it will bite deeper and deeper.When fully bitten, do not pull the head with great force, but slowly pull the head backward.Also, when sewing zippers, please do not leave hidden dangers.

4. Clothes worn for a long time are not good for pulling, because the pull head of the zipper becomes loose. At this time, you can use pliers (without pliers, you can also bite with your teeth) to pinch the pull head, so that the pull head becomes tight, and the zipper will be easy to use.